Installation and commissioning of CNC lathe with inclined bed

In the actual cutting process, the inclined bed CNC lathe has the function of matching power tools and 8 stations turret tool rest, so it can play an important role in the processing of different products, especially in the complex, high-precision parts obviously have the advantage of other products do not have.
Installation of CNC lathe with inclined bed
1, the inclined bed CNC lathe is placed on the foundation, must be levelled in free state, and locked by the anchor bolt.

2. For ordinary machine tools, the level reading will not be higher than 0.04/1000mm, and if it is a high-precision CNC machine tool, the level is not
It will be higher than 0.02/1000mm. When measuring the installation accuracy, we often need to carry out at a constant temperature, and the measuring tool needs to pass through a
Period of
Time fixed temperature after use.

3, oblique CNC lathe in the installation, to reduce the numerical control machine tool caused by forced deformation of the installation method.

4, oblique bed CNC lathe installation can not casually remove some parts of the machine tool, if the removal of some parts, it is likely to be made
The internal stress of CNC lathes should be distributed again, thus affecting the accuracy of machine tools.

Preparation of inclined bed CNC lathe before test run

1, before use, the inclined bed CNC lathe should pass the geometric accuracy test first, and then clean the whole machine. Specifically, is to use cotton cloth or silk containing detergent to wash, this stage may not use cotton or gauze, lest appear machine jam phenomenon, that is to say, the slant bed CNC lathes in the factory to protect the guideway and the machined surface and coated with anti-rust oil or wash away anti-rust paint, clean the surface dirt at the same time. At the same time, each sliding surface and working surface is coated with the manufacturer's specified lubricating oil.

2, also carefully check whether all parts of the inclined bed CNC lathe have been filled up with oil according to the relevant requirements, and whether the coolant in the cooling box is sufficient. Whether the oil of machine tool hydraulic station and automatic lubricating device can reach the part specified by oil level marker.

3. At the same time, check whether the switches and components in the electrical control box are normal and whether the integrated circuit board is in normal operation.

4, after the power, we also need to start the centralized lubrication loading, to ensure that there is enough lubricating oil on the lubricating part and lubricating oil road, in order to do a series of preparatory work before the use of the machine tool.